Flex FX3211 Manual Del Operador página 15

To reduce the risk of fire,
WARNING
product damage due to a short circuit, never
immerse your charger or battery pack in fluid
or allow a fluid to flow inside them. Corrosive
or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach-
containing products, etc. can cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
SWITCH BUTTON (FIG. 9)
The tool can be turned "ON" with the switch
button, located at the side of the motor housing.
The switch button can be locked in the "ON"
position, a convenience for long grinding
operations.
To turn the tool "ON" without locking it:
Slide the switch button forward by applying
pressure ONLY at the REAR portion of the
button.
This die grinder must be used only with the battery packs and chargers listed below:
2.5Ah 3.5Ah
FX0111 FX0321 FX0121 FX0331 FX0221 FX0341 FX0231
NOTICE: Please refer to the battery pack and charger manuals for detailed operating information.
OPERATING INSTRUCTIONS
personal injury, and
If any parts are damaged
or missing, do not operate
To prevent accidental
starting that could cause
Battery Pack
5.0Ah 6Ah 8.0Ah
Fig. 9
When pressure is released the switch button will
snap back to the "OFF" position.
To lock the switch "ON":
Slide the switch button forward, then press on
the FRONT portion of the button.
To unlock the switch:
Simply press and release the REAR portion of
the button. The switch is spring loaded and will
snap back automatically.
10Ah 12Ah
FLEX
FX0411
-15-
Switch Button
Charger
FLEX FLEX FLEX
FX0421 FX0431 FX0451