Flex FX3211 Manual Del Operador página 12

d. Insert the accessory all the way into the collet.
e. Exposed shaft length cannot be more than
25/64" (10 mm). The shank of the accessory
must be inserted at least 25/32" (20 mm) into
the collet (Fig. 4).
f. Press the spindle-lock button, securely tighten
the clamping nut using the collect wrench and
turning it clockwise (Fig. 5).
NOTICE: To prevent damage to collet, avoid
excessive tightening of the collet nut when there
is no accessory inserted.
To remove the accessory
a. Press the spindle-lock button, loosen the
collet nut by using collet wrench and turning it
counterclockwise (Fig. 3).
b. Pull the accessory out.
WARNING
accessory from the tool, or first allow it to
cool down. The accessory may be hot after
prolonged use.
WARNING
not secured to avoid objects flying out and
causing injuries and property damage.
CHANGING THE COLLET NUT (FIG. 6)
a. Remove the battery pack.
b. Press the spindle-lock button, loosen the
collet nut using the collet wrench and turning
it counterclockwise (Fig. 3).
c. Remove the collet nut from the spindle.
d. Position the new collet nut onto the spindle
(Fig. 6).
e. Press the spindle-lock button, securely
tighten the clamping nut using an open-ended
spanner and turning it clockwise (Fig. 5).
NOTICE: To prevent damage to collet, avoid
excessive tightening of the collet nut when there
is no accessory inserted.
Use protective gloves
when removing the
Do not start the machine
when the clamping nut is
Fig. 4
25/64" (10 mm) Maximum
Fig. 5
Collet
Wrench
Spindle-Lock
Button
Fig. 6
-12-
Accessory
Collet Nut