Live Picture Monitoring; Observing The Live Picture From A Particular Camera (Full-Screen Mode) - Sony HSR-X216 Manual De Instrucciones

Live Picture Monitoring

Live Picture Monitoring
You can watch live pictures from cameras by
displaying them on the main monitor (MONITOR 1)
and/or the sub monitor (MONITOR 2).
The main monitor and the sub monitor can be set
individually, so you can watch a live picture on one
monitor, while the other monitor is in playback mode.
Buttons used for live picture monitoring
MULTI button
QUAD button
OPTION button
MONITOR 2 button
MULTI QUAD OPTION MONITOR 2
ALARM RESET
POWER
1 2 3 4 5 6 7 8
ALARM
INPUT
ALARM FULL SELECTOR
9 10 11 12 13 14 15 16
FULL
DIGITAL SURVEILLANCE RECORDER HSR-X216P
INPUT SELECTOR buttons
Observing the Live Picture from
a Particular Camera (Full-Screen
Mode)
Press the INPUT SELECTOR button of the camera
whose picture is to be displayed.
The indicator of that button lights, and the picture from
the camera you chose is displayed full-screen.
Pressing the same button again restores the previous
mode.
To change the display on the submonitor
(MONITOR 2)
After pressing the MONITOR 2 button to light the
indicator, press the INPUT SELECTOR button
corresponding to the camera you wish to check. You
can watch the desired camera picture independently of
the main monitor.
To change the main monitor display, press the
MONITOR 2 button again so that the indicator goes
dark.
20
(GB)
SHUTTLE
-
l ALARM L HOLD
LOCK
PRE REVERSE PLAY
MENU EXIT/OSD
S PAUSE s STOP G PLAY
ZOOM SEARCH
SEQUENCE COPY
REC a REC
TIMER
STOP
PUSH
SEQUENCE button
ZOOM button
Switching the display automatically
Press the SEQUENCE button so that the indicator
lights.
The pictures are automatically displayed in sequence at
regular intervals (1 to 30 sec.). To cancel the
automatic switching operation, press the SEQUENCE
button again or press one of the INPUT SELECTOR
buttons so that the SEQUENCE indicator goes dark.
The switching interval can be specified in a menu
operation.
For the interval setting procedure, see "Specifying the
automatic switching interval" on page 24(GB).
Zooming in on a detail of a picture
In full-screen mode, you can zoom in on a detail of a
picture by pressing the ZOOM button.
1
Press the INPUT SELECTOR button
corresponding to the camera to be monitored and
display the picture full-screen.
2
Press the ZOOM button.
The unit enters Zoom mode, and the center part of
the picture is displayed on the monitor enlarged.
In Zoom mode, the ZOOM button indicator of this
unit flashes, and "Z" flashes on the monitor screen.
Note
In Zoom mode, the picture may be more or less
unclear. Pressing the INPUT SELECTOR button of
the selected camera repeatedly may improve the
picture quality.
To specify the area to be zoomed
At the initial setting, the center part of the picture is
zoomed in when the ZOOM button is pressed.
To specify the zoom-in area, proceed as follows after
step 2.
3
Hold the same INPUT SELECTOR button as in
step 1 pressed for about 3 seconds.
The picture is displayed in Normal mode, and a
frame to specify the zoom-in area appears centered
on the screen.