Network Connections And Associated Settings; Network Control - Sony HSR-X216 Manual De Instrucciones

Connections and Settings
Network Connections and
Associated Settings
Insert a commercially available LAN card (10BASE-T
or 100BASE-T) into the PC CARD slot on the rear
panel, and connect the unit to your network via the
card.
Three ID1 users who are permitted only to view the
live image and one ID2 or ID3 user can simultaneously
access the unit. When multiple users are accessing, the
number of connected users is displayed on the screen.
Connection
Attach a ferrite core to an Ethernet cable, and connect
the cable to a LAN card.
HSR-X216/X209P/X216P
1 2 3
IN
OUT
S VIDEO
PC CARD
LAN card
Ethernet cable
Ferrite core (supplied with
the HSR-X209P/X216P only)
Note
Be sure to disconnect the power to the HSR-X216/
X209P/X216P when attaching/detaching a LAN card.
54
(GB)
PC CARD
AUDIO IN AUDIO OUT
4 5 6 7 8 9 10 11
MONITOR 1 MONITOR 2
ETHERNET
Wind the cable
then snap.
Settings
Perform the necessary settings with the submenu
6. NETWORK SET of the main menu 3. GENERAL
SET.
For details on menu operations, see "Menu Operations" on
page 15(GB).
<NETWORK SET>
LAN CARD
NETWORK CONTROL : ON(DISPLAY:ON )
IP ADDRESS
SUBNET MASK
GATEWAY
PORT
ID
ID1
ID2
ID3
LAN CARD: Select the type of your LAN card.
Network card setting (LAN1 or LAN2) differs
depending on network interface specifications.
Please set as follows:
LAN1: COREGA FEtherPCC-TXD or equivalent
(100BASE-TX/10BASE-T type)
LAN2: COREGA FEtherPCC-TD or equivalent
(10BASE-T type)
For a list of applicable LAN cards, consult your Sony
dealer.
NETWORK CONTROL: Set to ON to enable
controls via the network.
Two different ON modes are selectable.
ON (DISPLAY ON): A message "NETWORK
CONTROL" is displayed on the screen of the
monitor connected to the recorder while the unit
is being controlled via a network. The playback
picture will be displayed on the monitor
connected to the recorder when the unit is in
Playback mode triggered via a network.
ON (DISPLAY OFF): No message is displayed
on the screen of the monitor connected to the
recorder while the unit is being controlled via a
network. The live image from a camera is
always displayed on the monitor connected to
the recorder even while the unit is in Playback
mode triggered via the network. The PLAY
button does not light even in Playback mode.
OFF: Control via a network is disabled.
IP ADDRESS: Set the address to be used to access
this unit.
For effective addresses, ask your system
administrator.
: LAN1
: 192.168. 0. 1
: 255.255.255.000
: 0.0.0.0
: 00080
PASSWORD (4-8)
: 1111----
: 2222----
: 3333----