Publicidad
1. NOTE FROM THE MANUFACTURER
Thank you for choosing one of our models. Please read this manual carefully. It's intention is to give you advice on
installation, use and maintenance. If you need any further clarification, please contact your dealer or the manufacturer
directly.
Our models are designed to improve the performance of any conventional fireplace. The fans circulate the air inside
the convection chamber that surrounds the fireplace. Air enters through the bottom of the front and comes out hot
at the top. Optionally, the hot air can also be blown to the top of the chimney hood and to other surrounding rooms.
The fireplace's interior is made of high-quality steel and depending on the model, can be covered with pieces of
refractory material or vermiculite plates.
Note: Graphic representations and drawings included in this manual may not correspond exactly with your model.
2. INSTALLATION
All our models are designed and manufactured for optimal performance. However, the operation and performance
you get will depend largely on the installation
WHAT YOU SHOULD KNOW
Before Installing "
AIR INLET FOR COMBUSTION.
In order to obtain combustion, oxygen is necessary. In current homes that are normally well insulated, with smoke
extractors or other similar devices, it is necessary to guarantee the supply of oxygen.
This model has an air inlet that is located in the lower part of the stove and it is designed to be connected to the
exterior, assuring the proper oxygen supply.
Warning. – In the case that the optional legs are not purchased. You must make sure to keep space
of 4 cm, below the unit to assure the correct air supply needed for the combustion.
If it is not possible to make this external air intake for combustion in your installation, you must ensure that the
stove can absorb the necessary air through this intake.
In this case take the following precautions:
-
It's better that the stove takes the air from the room, do not leave the air inlet inside the chimney chamber,
enable the connection so that the stove takes the air from the room, and make sure that there is a supply of
.
".
Air inlet for combustion
16
Publicidad
