Publicidad
2.3 General installation Recommendations
The installation of the appliance must comply with all local regulations, including those that refer to national and
European standards.
Although the following describes an example installation to ensure good performance, it may not be ideal for your
circumstances. In any case, the installation should be done by an authorised installer.
CARBEL will be responsible for the provided appliance, but in no case for the installation of the same.
The building work must be finished in such a way that the wood burner can expand during operation: the brickwork
must never be supported on or against the sides of the appliance. Leave a minimum expansion joint of 0.5 cm on each
side and at least 1 cm the top of the front.
JUNTA DE DILATACION MIN.: 0'5 cm
EXPANSION JOIN: 0'5 cm.
Vista en planta / Top wiev
Warning. - Any installation should be done by an authorised installer. A faulty installation of this product, and an inadequate
maintenance might cause grave incidents.
1. Fumes exhaust pipe Ø 200.
2. Entry of air into the chimney
chamber by natural convection.
3. Entry of air into the cassette
convection chamber, drawn in by
fans.
4. Hot air outlet at the top of the
front blown by fans
5. Hot air outlet driven by fans.
6. Hot air outlet of the chimney
chamber by natural convection.
7. Optional outlet for hot air to other
rooms, blown by fans
8. Optional outside air inlet for
combustion Ø 80.
JUNTA DE DILATACION MIN.: 1cm
EXPANSION JOIN: 1 cm.
Vista de perfil
Side wiev
20
Publicidad
