Publicidad
3. 8 Tips for using your cassette and OPTIMAL adjustment of the air intakes:
Once the unit has completed a first combustion cycle and it is hot enough, it is advisable to follow these
recommendations to get the most out of your product.
Spread the embers from previous combustion cycles across the bottom of the burner.
It is preferable to use splitted logs or similar wood with a humidity percentage of less than 20%.
Recommended fuel size:
Mod. I 70 DC: Two pieces of wood between 30 and 35 centimeters in length and 1 to 1.3 kg weight.
Mod. I 80 DC: Two pieces of wood between 35 and 40 centimeters in length and 1 to 1,5 kg weight.
Mod. I 100 DC: Two pieces of wood between 35 and 50 centimeters in length and 1,2 to 1,8 kg weight.
When reloading place the wood pieces according to the drawing below.
-
Set the primary air inlet to an opening of between 5 and 8 mm.
-
Set the secondary air inlet to 30% of its range.
-
To obtain stable and optimal performance and a clear view of the flames through the glass try to make consecutive
loads of wood with pieces as similar as possible, for that you must keep the same air inlet regulation at any time.
4. MAINTENANCE
To clean the glass, be careful to spray the cleaning product on a cloth and clean only the glass, without wetting the
rest of the door. Window-cleaners and special products often contain chemicals that attack the paint and the ceramic
fiber seals and cause oxidation of the metal parts.
It is very important not to wet the wood burner with window-cleaner, water or special cleaning products.
Heatproof paint is not waterproof.
Clean the paintwork with a feather duster or a soft, dry cloth. If over time you want to repaint the insert, the
manufacturer makes a spray paint available from your dealer.
5. TIPS, CHIMNEY SWEEPING and SAFETY STANDARDS
Whenever the stove is used, there is a certain risk that must be taken into account. Therefore, the following
instructions must be observed:
Position of the Wood pieces.
26
Publicidad
