Publicidad
3. Leave the door with an opening between 0,5cm to 3cm, so that enough air can enter for the fire to light quickly.
4. Once the wood is well-lit, wait until the wood burner temperature is high before completely closing the door
(10 to 45 minutes, depending on factors like wood, air circulation, etc.) and adjust the air inlet. If you find that
the volume of flames decreases, or the fire tends to go out and the smoke inside the fireplace increases, open
the air intake more or repeat step 3.
When you reload with more wood, if there are not enough embers to light the new load of wood, repeat steps 3 and
4.
When the wood burner is in operation, you must not open the door. When putting more wood on the fire, open the
door slowly to prevent the smoke inside the fireplace from blowing out into the room.
3. 5 Adjusting primary and secondary air inlets
You have purchased an insert model that offers maximum efficiency and performance. Therefore, control of the
primary and secondary air inlet is essential to achieve optimum combustion levels.
The optimal regulation of the air inlets can vary depending on various factors, such as the chimney flue, the
temperature of the wood burner, the quality of the wood (moisture, size and shape).
1
2
In order to avoid burns while regulating air flow, use always the glove and the regulation
lever provided with the appliance.
CLOSE
CLOSE
(1) SECONDARY air inlet regulation.
(2) PRIMARY air inlet regulation.
OPEN
OPEN
24
Publicidad
