Angelo Po 0S1FR1E Manual De Uso página 136

ENGLISH
WARNING: The connection must be
made by authorised, skilled personnel, in
accordance with the relevant legal require-
ments, using appropriate and specifi ed ma-
terials. The appliance is supplied with op-
erating voltage of 400V/3N, which can be
switched to 230V3~ (see next section).
HAZARD: Before doing any work, cut
off the mains electricity supply.
Connect the appliance to the mains electricity
supply as follows.
If not already in place, install an automatic
)
switch-disconnector (A) close to the appli-
ance with thermal magnetic circuit breaker
and residual-current circuit breaker.
Open the hatch (B).
)
B
10
ELECTRICAL CONNECTION
Undo the screws (C) to remove the lid (D).
)
Connect the circuit-breaker (A) to the ter-
)
minal board (E) of the appliance as shown
in the diagram and in the electrical sys-
tem diagram at the back of the manual.
Use a fl exible cable with at least type H07RN-
F characteristics, rated for an operating tem-
perature of at least 80°C.
tention to the neutral and earth cable con-
nection.
Tighten the cable gland (F).
)
Replace the lid (D) and fi x it with the screws
)
(C) on completion of the operation.
Close the hatch (B).
)
C
A
HANDLING AND INSTALLATION
WARNING: When connecting, pay at-
E
F
3395260_inst_GB_rev.1
D