Use; Switching The Device On And Off; Turning The Device On - Mectron MULTIPIEZO Manual De Uso

MULTIPIEZO
Correctly connect the handpiece on its
cord making sure to match the dot on the
handpiece connector with the groove on the
cord connector.
Make sure that the electrical contacts of
both handpiece and cord are perfectly dry;
if need be, dry them by blowing compressed
EN
air;
Position the handpiece on its support.
05 Û USE
05.1 Û SWITCHING THE DEVICE ON AND OFF

Turning the device on

With the device in view from its front side,
position the switch on the left of the device
body on position "I", being careful not to press
the foot pedal.
4 symbols appear on the device (ref. U inside
cover) that turn off one by one. At this point, the
device sets on the default setting and is ready
for it to be used.
Turning the device off
With the device in view from its front side,
position the switch on the left of the device
body on position "O", being careful not to press
the foot pedal.
The device turns off.
CAUTION: Always position the device
in way so that the power switch is easily
reachable, since this switch is considered
as a load-break
12
switch.
6
7
PLEASE NOTE whenever the device is
started, the following default setting is
programmed:
"power" 1
"light" AUTO
"function" ENDO
"irrigation" 3