Electromagnetic Compatibility En 60601-1-2; Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Mectron MULTIPIEZO Manual De Uso

11.1 Û ELECTROMAGNETIC COMPATIBILITY EN 60601-1-2
WARNING: Interference with other
equipment. Though compliant with the
standard IEC 60601-1-2, the multipiezo may
nonetheless interfere with other devices
nearby.
The multipiezo must not be used near to
or stacked on other devices. However, if
this were to prove necessary, you must
check and monitor correct operation of the
device in that configuration.
WARNING: Portable and mobile radio
communication appliances may affect the
correct functioning of the device.

Guidance and manufacturer's declaration - Electromagnetic emissions

The multipiezo is intended for use in the electromagnetic environment specified below. The
customer or user of the multipiezo should ensure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations /
flicker emissions
IEC 61000-3-3
equipment. An electrical scalpel or other
electro-surgical units near the multipiezo
device may interfere with its correct
operation.
EMC precautions and must be installed
and activated in accordance with the EMC
information given in this paragraph.
Compliance Electromagnetic environment – Guidance
Group 1
The multipiezo only uses RF energy for internal
function. Therefore, its FR emissions are very
low and are not likely to cause any interference
with nearby electronic
equipment.
Class B The multipiezo is suitable for use in
all establishments, including domestic
establishments and those directly connected to
Class A
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Complies
11 Û TECHNICAL DATA
WARNING: Interference from other
WARNING: The device requires specific
EN
39