GYS EXAGON 400 FLEX CC/CV Manual Del Usuario página 19

MODE SELECTION
Press the button several times until the LED light switches on below the symbol
The MMA vertical up mode adds a current pulse which makes vertical up welding easier.
MAIN SETTINGS
1. Selection of the electrode's coating type :
Selection of the electrode's coating type by maintaining the
symbol.
2. Welding intensity settings :
Adjust the welding current using the main knob
setpoint is indicated on the right side display.
3. Arcforce settings :
Adjust the arcforce level with the right side knob
The higher the arcforce, the higher the extra welding current . The default value is 0.
WELDING PARAMETERS
WELDING INTENSITY SETTINGS
The following settings concern the intensity range that may be used depending on the electrode's type and diameter . These ranges are quite large
as they depend on the application and the welding position.
Ø electrode (mm)
1.6
2.0
2.5
3.15
4.0
5
6.3
ARCFORCE SETTINGS
It is recommended to set the arc force in median position (0) to start the welding and adjust it according to the results and welding preferences.
Note : the arcforce setting range is specific to the selected electrode type.
ADVANCED SETTINGS
Refer to the chapter « menu access » for more details regarding welding parameters.
The two MMA modes and
: HotStart, level of the extra current at arc strike, expressed in percentage of the welding current.
: Hotstart Time, duration of the extra current at arc strike, expressed in seconds.
: Antisticking, active (On), the current will stop after 2 consecutive seconds of short circuit, inactive (Off), the current will not stop, even in
the event of long short circuit.
In MMA vertical up mode , two extra settings are available :
: Frequency, determines the number of pulses per second (Hz).
: Percentage, determines the background/cold current expressed in percentage of the welding current.
TUNGSTEN ELECTRODE WELDING WITH INERT GAS (TIG
CONNECTIONS AND RECOMMENDATIONS
TIG welding requires a torch as well as a gas bottle equipped with a regulator.
Connect the earth clamp to the positive connector (+).
Connect the torch's earth cable to the negative plug (–).
Connect the torch's gas hose to the regulator's output.
Ensure that the torch is equipped and ready to weld, and that the consumables (Vise grip, ceramic gas nozzle, collet and collet body) are not damaged.
EXAGON 400 FLEX CC/CV
button for more than 3 seconds until the LED switches on below the corresponding
according to the electrode diameter and the type of assembly to be carried out. The current
, a relative value from -9 to +9. The lower the arcforce, the softer the arc.
Rutile E6013 (A)
30-60
50-70
60-100
80-150
100-200
150-290
200-385
come with the following additional settings :
or .
Basic E7018 (A)
30-55
50-80
80-110
90-140
125-210
200-260
220-340
)
EN
Cellulosic E6010 (A)
-
-
60-75
85-90
120-160
110-170
-
19