Tritech 302-123 Manual Del Propietário página 57

Idiomas disponibles

REPLACE TRANSDUCER

Follow pressure relief procedure before a�emp�ng to service or repair unit. See Page 47.

If trouble shoo�ng guide suggests replacing the transducer, follow the direc�ons below.

1. Remove 2 SCREWS #12, Diagram C, from the Controller Assembly plate, (Poten�ometer side of plate).

2. Remove 3 SCREWS #1, Diagram B, from the MOTOR COVER #3, Diagram B, and remove MOTOR COVER.

3. Unplug the TRANSDUCER wire (gray) from the Circuit Board. While using a pair of needle nose pliers to hold

the TRANSDUCER body form turning, loosen the TRANSDUCER nut #15, Diagram C, from the PUMP

HOUSING #9, Diagram A, with a ¾" open end wrench. Slide the TRANSDUCER out of the back of the PUMP

HOUSING.

4. Remove the GROMMET SLEEVE #16, Diagram B, by pulling it back towards the inside of the Controller

Assembly (pull it towards the Circuit Board).

5. With GROMMET SLEEVE removed from Controller Assembly plate, slide it over the TRANSDUCER lead wire

un�l the connector exits through the GROMMET SLEEVE.

6. Pull the TRANSDUCER lead and connector through the Controller Assembly plate.

7. To install the new TRANSDUCER, begin by sliding the connector through the CONTROLLER ASSEMBLY plate,

then through the GROMMET SLEEVE while GROMMET SLEEVE is in the Control Board compartment.

8. Slide the GROMMET SLEEVE through the Controller Assembly plate un�l seated.

9. Posi�on the TRANSDUCER nut #15, Diagram C into the PUMP HOUSING #9, Diagram A. Make sure the

O-RING is on the end of the TRANSDUCER body. Begin threading the TRANSDUCER nut into the PUMP

HOUSING.

10. While using a pair of needle hose pliers to hold the TRANSDUCER body for turning, �ghten the

TRANSDUCER nut into PUMP HOUSING #9, Diagram A, with a ¾" open end wrench.

11. Plug the TRANSDUCER (gray) lead back into the Circuit Board connector JP4.

12. Install MOTOR COVER #3, Diagram B back onto the assembly. Install 2 SCREWS #12, Diagram C, through

the Control Plate (Poten�ometer side of plate).

13. Install 3 SCREWS #1, Diagram B into MOTOR gearbox cas�ng #5, Diagram B to complete reassembly.