Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Unplug
changing the oper-
ating mode.
Disengage locking
pin
saw mode.
Let
engage for table
saw mode.
Information on the nameplate:
20
21
22
23
26
24
25
(20) Manufacturer
(21) Serial number
(22) Machine designation
(23) Motor specifications (see also
"Technical specifications")
(24) Year of make
(25) CE-mark – This machine con-
forms to the EC directives as per
Declaration of Conformity
(26) Waste disposal symbol – the
machine can be disposed of
through the manufacturer
(27) Dimensions of permissible saw
blades
4. Special product features
− Sturdy and high-precision die-cast
aluminum design for highest tor-
48
before
sional resistance and accuracy at
low weight.
− Operating mode conversion from
crosscut saw to table saw without
tools in seconds, by simply turning
the saw table over.
− Foldable workstand – ideal for site
use.
− In crosscut saw mode, the saw head
tilts steplessly through 45°.
− The rotating table turns steplessly
through 45° left and right.
− Will cut compound mitres up to 45°.
− Large-dimensioned saw table pro-
vides a clean, flush support area.
− Robust drive, insensitive to dust.
− Low wear poly-V-belt for optimal
power transmission and long service
life.
5. Installation and transport
5.1
Machine setup
A
Caution!
for
crosscut
Do not carry the machine at the
table; the table is not designed to
locking
pin
bear the weight of the machine.
1.
With two persons, hold the machine
at the front (28) and rear (31)
recessed grips and lift it out of the
packaging.
2.
Lay machine on its rear side.
3.
Loosen the locking clips (29) and
swing legs out until they engage at
the side panel.
28
27
31
4.
Hold machine at the rear recessed
grips (31) and lift it up into vertical
position.
5.
If necessary, compensate for an
uneven floor with the adjusting foot
(30).
3
Note:
See the description of the respec-
tive operating mode for details about the
initial operation in crosscut saw or table
saw mode.
29
30
5.2
Machine transportation
1.
Swing saw table over in position
table saw mode (see "Table saw
mode").
2.
Remove blade guard (32).
3.
Lower saw blade (33) fully.
4.
Remove rip fence (34), if necessary.
5.
Hold saw at the rear recessed grips
(35) and lay it on its rear.
32
33
34
35
36
39
6.
Run power cable between the two
left legs (39).
7.
Unlock the legs on the left (39) and
fold up.
8.
Unlock the right legs (37), fold over
the left legs and secure with the
locking clips (38).
9.
Hold saw at the tubes (36) below the
saw table when transporting.
If possible use the original carton for
shipping.
5.3
Mains connection
B
Danger! High voltage
•
Operate machine in dry environ-
ment only.
•
Operate machine only on a power
source matching the following
requirements (see also "Techni-
cal specifications"):
− outlets
properly
earthed and tested;
− mains voltage and system fre-
quency conform to the voltage
and frequency shown on the
machine's nameplate;
− fuse protection by a residual
current operated device (RCD)
of 30 mA sensitivity;
− system impedance Z
interconnection point (house
service connection) 0.35 Ohm
maximum.
37
38
installed,
at the
max.
Publicidad
