Publicidad
Idiomas disponibles
Idiomas disponibles
3
Note:
Check with your local Electric-
ity Board or electrician if in doubt
whether your house service connec-
tion meets these requirements.
•
Position power supply cable so it
does not interfere with the work
and is not damaged.
•
Protect power supply cable from
heat,
aggressive
sharp edges.
•
Use only rubber-jacketed exten-
sion cables with sufficient lead
cross-section (3 x 1.5 mm
•
Do not pull on power supply
cable to unplug.
6. General operating ele-
ments
ON/OFF switch (40)
•
To start = press green switch button.
•
To stop = press red switch button.
40
•
To restart
− when
motor
protection
tripped (e.g. because of a locked
motor) or
− after a power failure (undervolt-
age relay tripped),
the green switch button must be
actuated again.
7. Crosscut and mitre saw
mode
7.1
Safety devices
Retractable blade guard
The two-piece retractable blade guard
protects against unintentional contact
with the saw blade and from chips flying
about.
liquids
and
Both segments of the retractable blade
guard (41) must always return automati-
2
).
cally into their starting position: when the
sawhead is lifted up, the sawblade must
be covered all around.
Sawhead lock
The sawhead lock prevents inadvertent
lowering of the sawhead onto the saw
table.
The sawhead lock is released with the
release lever (42). The sawhead lock
has
must always engage when the sawhead
is in the upper starting position.
7.2
A
•
Prior to machine setup: Turn
machine OFF, unplug, and wait
for the sawblade to stop.
1.
Lower saw blade fully.
2.
Install chipcase (43) on the saw
table: First insert the two tongues,
then secure chipcase in place with
the T-handle lock (44).
44
41
42
Setting up for crosscut
and mitre saw mode
Danger!
A
Risk of crushing!
When turning the saw table
over there is a risk of crushing!
•
Do not reach between saw table
and side panels!
•
Hold the saw table firmly when
turning over, so it will not drop all
of a sudden!
•
Make sure the sawhead is firmly
locked and secured against unin-
tended tilting!
3.
Pull lever (45) forward and turn the
saw table gently over.
4.
Connect the chip case's dust extrac-
tion port to a suitable dust collector.
5.
Pull out the locking pin (46) for the
height adjustment and turn clock-
wise by a quarter turn.
6.
Loosen the locking nut (47) of the
riving knife (48).
48
43
7.
Swing riving knife up and tighten the
locking nut.
8.
Install auxiliary fences (49), leaving
approx. 5 mm distance to the cutting
area. Tighten retaining brackets
(50).
ENGLISH
45
46
47
49
Publicidad
