Publicidad
Idiomas disponibles
Idiomas disponibles
Wall Mounting Storage
Installation
For convenient storage of the hand-
held vacuum cleaner and its
accessories, this product includes a
storage mount specifically designed to
hang and store the device.
NOTE: Mount the wall bracket at a
suitable point using the screws
supplied. (Add wall anchors if you deem
necessary to secure the mount to the
wall).
Material damage due to incorrect
installation
NOTE: Incorrect installation can
damage the device, wall, and the floor
covering if it falls.
NOTE: Use suitable mounting tools for
wall mounting.
10 English
NOTE: Take the weight of the device
and the loading capacity of the
installation location into account when
selecting the fasteners.
Risk of electric shock and injuries
Make sure there are no electrical
cables, water or gas pipes in the wall
around the mounting area.
1. Put the assembled hand-held
vacuum cleaner into the mount and
stand the hand-held vacuum cleaner
upright, near the ground. The height
should be high enough so that the
roller head of the assembled vacuum
cleaner does not touch the ground.
2. Once the correct height for the mount
is determined, holding the mount in
place, remove the hand-held vacuum
cleaner, mark the hole placement in
the center of the mount, place the
screw, and tighten it until snug
against the wall.
3. After the center screw is installed,
make sure the mount is level and
then mark the lower hole, place
screw, and tighten until snug against
the wall.
Publicidad
