Stihl HTA 65 Manual De Instrucciones página 51

4 Safety Precautions
► Stand on the ground while working and keep a good
balance. If it is necessary to work at heights: Use a lift
bucket or a safe platform.
► If you begin to feel tired: Take a break.
￭ The rotating saw chain can cut the operator. This can
result in serious injuries.
► Do not touch the rotating saw chain.
► If the saw chain is blocked by an object: Switch off the
pole pruner and remove the battery. Then remove the
object causing the blockage.
￭ The rotating chain becomes hot and expands. If the chain
is not lubricated sufficiently and re-tensioned at regular
intervals, it man come off the guide bar or break. This can
result in serious injuries and damage to property.
► Use special chain oil.
► Check chain tension regularly during cutting work. If
chain tension is insufficient: Tension the chain.
￭ If the behavior of the pole pruner changes during
operation or feels unusual, it may no longer be in a safe
condition. This can result in serious injuries and damage
to property.
► Stop work, remove the battery and contact your STIHL
servicing dealer for assistance.
￭ Vibrations may occur while using the pole pruner.
► Wear gloves.
► Take regular breaks.
► If signs of circulation problems occur: Seek medical
advice.
0458-766-9921-B
￭ Sparks may occur if the rotating chain makes contact with
a hard object. Sparks may cause a fire in an easily
combustible location. This can result in serious or fatal
injuries and damage to property.
► Do not work in an easily combustible location.
￭ Note that the saw chain continues to rotate for a short
period after you release the trigger. The rotating saw chain
can cut the user. This can result in serious injuries.
► Hold the pole pruner firmly with both hands and wait
until the saw chain comes to a standstill.
1
2
WARNING
￭ The guide bar can be pinched when cutting wood that is
under tension. The user can lose control of the pole
pruner, stumble or fall and be seriously injured.
► Make a relieving cut in the compression side (1) first,
then perform bucking cut at the tension side (2).
English
2
1
49