Filling Up With Chain Oil - Stihl HTA 65 Manual De Instrucciones

English
– The chain fits snugly against the underside of the bar.
– The chain can still be pulled easily along the bar with
two fingers.
► If a Carving guide bar is used: Turn the tensioning screw
(1) clockwise until the drive links on the underside of the
bar are just half visible.
► If the chain can no longer be pulled along the bar by hand:
Turn the tensioning screw (1) counterclockwise until the
chain can be pulled easily along the bar with two fingers.
► Tighten down the nut (2).
7.3

Filling Up with Chain Oil

Chain oil lubricates and cools the rotating chain.
► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► Place pole pruner on a level surface so that the oil tank
cap faces up.
► Use a damp cloth to clean the tank cap and the area
around it.
► Swing the grip on the oil tank cap to the vertical position.
► Turn the oil tank cap counterclockwise as far as stop.
► Remove the oil tank cap.
► Fill up with chain oil, taking care not to spill any oil and do
not overfill the tank.
► If the grip on the oil tank cap has dropped into the closed
position: Raise the grip until it is vertical.
56
1
2
► Place the cap in the filler opening so that mark (1) lines up
with mark (2).
► Press the cap down and rotate it clockwise as far as stop.
The cap snaps into place. The mark (1) points to mark (3),
► Check to see if the oil tank cap can be pulled upwards and
off.
► If the oil tank cap cannot be pulled upwards and off: Fold
down the grip on the oil tank cap.
The oil tank is closed.
If the oil tank cap can be pulled upwards and off, perform the
following steps:
► Place the oil tank cap in the filler opening – in any position.
► Press the cap down and rotate it clockwise as far as stop.
► Press the cap down and rotate it counterclockwise until
mark (1) points to mark (2).
► Now try again to close the oil tank.
7 Assembling the Pole Pruner
1
3
2
0458-766-9921-B
1