Charging The Battery, Leds; Charging The Battery; Displaying State Of Charge; Leds On Battery - Stihl HTA 65 Manual De Instrucciones

English

6 Charging the Battery, LEDs

6.1

Charging the Battery

The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see www.stihl.com/
charging-times.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
6.2

Displaying State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 19.
There is a malfunction in the pole pruner or battery.
54

7 Assembling the Pole Pruner

7.1
7.1.1
The bar and chain combinations that can be used with the
chain sprocket are listed in the specifications, @ 21.
► Switch off the pole pruner, push retaining latch to position
and remove the battery.
80-100%
60-80%
40-60%
20-40%
0-20%
► Rotate the nut (1) counterclockwise until the chain
sprocket cover (2) can be removed.
► Remove the chain sprocket cover (2).
► Turn the tensioning screw (3) counterclockwise until the
tensioner slide (4) butts against the left end of the
housing.
6 Charging the Battery, LEDs

Mounting and Removing the Bar and Chain

Mounting the Bar and Chain
4
2
1
3
0458-766-9921-B