Specifications; Stihl Hta 65, Hta 85 Pole Pruners; Chain Sprockets And Chain Speeds; Minimum Groove Depth Of Guide Bars - Stihl HTA 65 Manual De Instrucciones

20 Specifications

20 Specifications

20.1 STIHL HTA 65, HTA 85 Pole Pruners

HTA 65
– Approved batteries:
– STIHL AP
– STIHL AR
– Weight without battery: 3.4 kg
– Max. oil tank capacity: 105 cc (0.105 l)
HTA 85
– Approved batteries:
– STIHL AP
– STIHL AR
– Weight without battery: 4.5 kg
– Max. oil tank capacity: 105 cc (0.105 l)

20.2 Chain Sprockets and Chain Speeds

The following chain sprockets may be used and produce the
maximum chain speed quoted below:
– 6-tooth for 1/4" P: 13.3 m/s

20.3 Minimum groove depth of guide bars

The mininum groove depth depends on the pitch of the guide
bar.
– 1/4" P 4 mm

20.4 STIHL AP battery

– Battery Technology: Lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
0458-766-9921-B
– Weight in kg: see rating label
– Permissible temperature range for operation and storage:
-10°C to +50°C

20.5 Noise and Vibration Data

K-value for noise pressure level is 2 dB(A). K-value for noise
power level is 2 dB(A). K-value for vibration level is 2 m/s².
HTA 65
STIHL recommends that you wear hearing protection.
– Sound pressure level L
pA
ISO 22868: 76 dB(A)
– Sound power level L
wA
ISO 22868: 93 dB(A)
– Vibration level a measured according to ISO 22867
hv
– Control handle: 2.5 m/s²
– Handle hose: 2.5 m/s²
HTA 85
STIHL recommends that you wear hearing protection.
– Sound pressure level L
pA
ISO 22868: 76 dB(A)
– Sound power level L
wA
ISO 22868: 93 dB(A)
– Vibration level a measured according to ISO 22867
hv
– Control handle: 1.0 m/s²
– Handle hose: 1.0 m/s²
The vibration values quoted above have been measured
according to a standardized test procedure and may be used
to compare electric power tools. Depending on the type of
usage, the vibrations that actually occur may differ from the
values quoted. The vibration values quoted may be used for
an initial assessment of the user's exposure to vibrations.
The actual exposure to vibrations has to be estimated. This
process may also take into account times during which the
electric power tool is switched off and times during which it
is switched on but running off load.
measured according to
measured according to
measured according to
measured according to
English
67