Progress PBN 1310 Instrucciones De Uso página 18

18 progress
8 ) Turn both the toggles 90° and pull these
out of their place.
9 ) Carefully lift the top pane out a little and
pull out the pane which is visible on all
four sides of the frame.
Clean the oven door with lukewarm water
and a soft cloth. Do not use any scourers,
metal wool, abrasive sponges or acids which
could damage the heat reflecting special
surfaces of the inner pane.
After cleaning the inner pane put back in the
door. Insert the door in the oven; proceed in
reverse order. Be mindful of the correct
alignment of the panes.
Proceed as follows:
The inner pane with the frame on four sides
must be installed so that the screen faces the
outside of the oven. Touch the visible surface.
If there is no roughness on the level of the
screen, the pane is inserted correctly.
The inner pane must be put in its place
according to figure.
After putting the panes in the oven door,
secure them in reverse order, following the
guidelines in Point 8.
Never clean the oven door while
warm as the panes can shatter. If
you notice scratches or flaws on
the glass panes, call customer
services immediately and arrange
for the pane to be changed.
Models in stainless steel or
aluminium: Clean the oven door and
the panel controls made from
stainless steel or aluminium with a
damp sponge and afterwards dry
them carefully with a soft cloth. Do not
use any scourers, metal wool, acids
or abrasive materials which could
scratch the surfaces.
Cleaning the oven door seal
A seal is affixed to the opening of the oven.
Check the condition of the seal
regularly. Clean the seal when
necessary, without using objects
or abrasive materials.
If you notice damage to the seal,
call the nearest customer service
immediately. Do not use the oven
whilst the seal is not in place.
90°
2
1