cecotec BONGO Z+ ON ROAD Manual De Instrucciones página 32

ENGLISH
7. SET
8. Cruise control
9. Bluetooth
10. MODE
11. LIGHT
12. Total kilometrage
13. Battery
14. Real-time tension monitoring
PLEASE NOTE:
The graphics in this manual are schematic representations and may not exactly match the
product.
3. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent product damage when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the Technical Support Service
of Cecotec.
Box contents:
Fig. 25
1. Bongo Cecotec Z+ On Road/Bongo Cecotec Z+ Off Road electric scooter
2. Charger
3. Tools required for assembly
4. Instruction manual
4. PRODUCT ASSEMBLY
Note:
This electric scooter is delivered folded and with the handlebars removed, so you will need to
do a little assembly before it is ready for use.
Assembling the handlebar. Fig. 26
1. Adjust the brake levers to the desired height and secure them.
BONGO Z+ ON ROAD
62
BONGO Z+ OFF ROAD
ORIGINAL MANUAL TRANSLATION
2. Align and insert the handlebar base into the handlebar fixing hole.
3. Adjust the direction and secure the handlebar with five screws.
Assembling the rear mudguard with number-plate holder. Fig. 27
1. Insert the rear mudguard into the rear suspension arms.
2. Pay attention to both sides of the mudguard when inserting it. It must be centred with the
holes in their correct position, left and right.
3. To attach the mudguard, screw it on both sides.
Kickstand. Fig. 28
The kickstand is located on the left side of the electric scooter. Push it down to unfold it.
Folding system. Fig. 29
1. Loosen the screw of the folding system until the screw is out of the folding area, but do
not pull it out.
2. Lower the shaft
3. Hook the retaining strap onto the controller cover.
How to charge the electric scooter
1. Make sure the electric scooter is switched off before and during charging.
2. Connect the charger to the electric scooter's charging port and connect the charging plug
to a power outlet.
- During the first charge, charge the electric scooter for at least 8 hours before use.
- The charger's light indicator will change from red (charging) to green once charge is
complete.
- Never use the electric scooter while it is charging.
- Do not charge the electric scooter for longer than necessary.
- To maximise battery life, charge the battery at least every three months.
Note:
Stop charging the battery when the indicator colour changes. Do not exceed the battery
charging time so as not to affect its shelf life. Standard charging time is approximately 8 hours.
WARNING!
Cover the charging port with the anti-dirt tap to prevent any metallic object from coming into
contact with it and to avoid short circuits.
ENGLISH
BONGO Z+ ON ROAD
63
BONGO Z+ OFF ROAD