Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
5. OPERATION
Power and operation
Fig. 30
1.
Hold the handlebars with your hands, step on the footrest with one foot, and step on the
ground with the other. Propel the scooter forward (initial speed is 3 km/h) and press the
accelerator.
2.
Keep your body and the electric scooter balanced facing forward.
3.
Turn the handlebar with both hands.
4.
When you need to brake, hold the handlebars firmly and brake with both levers applying
the desired force. When slowing down and stopping, you should place one foot on the
ground to keep your balance.
WARNING!
-
Do not ride too fast.
-
The display shows the battery level. Make sure the battery is fully charged before using
the electric scooter, especially in case of long journeys.
Riding modes
1.
PEDESTRIAN mode: the mode indicator on the display will show 1. In this mode, the
scooter can reach 6 km/h.
2.
NORMAL mode: the mode indicator on the display will show 2. In this mode, the scooter
can reach 15 km/h.
3.
SPORT mode: the mode indicator on the display will show 3. In this mode, the scooter can
reach 25 km/h.
PLEASE NOTE:
Speeds were measured with an 80-kg weight, a completely charged battery, tyres with
optimum pressure, on a flat surface with no wind, and a room temperature of approximately
25ºC.
Tyre use
-
For a correct operation of the electric scooter, you should check and ensure the correct
pressure on your tyres before every use.
-
The optimum pressure for these tyres is de 30 PSI / 2.1 bars / 210 kPa.
-
We recommend you carry out periodic tests to ensure the pressure is between the
recommended values to achieve efficient operation.
-
During the shelf life of these tyres, we recommend using heat-sealing gels to prevent
punctures and maintain maximum effectiveness and performance.
BONGO Z+ ON ROAD
64
BONGO Z+ OFF ROAD
ORIGINAL MANUAL TRANSLATION
6. CLEANING AND MAINTENANCE
-
Make sure the product is not plugged in the power supply or on before cleaning, charging,
or maintenance.
-
Use a soft cloth to clean the exterior housing of the electric scooter.
-
Never use alcohol, petrol, paraffin, and corrosive or abrasive products to clean the electric
scooter.
-
Never immerse the electric scooter in water or any other liquid to clean it, as this could
damage the electronic parts permanently.
-
Never use pressurised water to clean the electric scooter.
-
Do not try to repair the electric scooter on your own. In case it does not operate correctly,
or it is damaged, please, contact Cecotec Technical Support Service.
-
Self-tapping nuts and other fasteners may loosen their hold and need to be retightened.
Brake discs
You must check the brake discs are in perfect condition, matching the brake caliper. To set this
easily there is an Allen key included. Brake pads are consumable parts and must be replaced
when its shelf life expires.
Storage
-
Make sure the electric scooter is charged before storing it for long periods of time. Charge
it at least once a month.
-
Charge it only if the room temperature is between 5ºC and 45ºC and store it at a temperature
between -10ºC and 50ºC.
-
Do not store the electric scooter outdoors. Store it in a safe and dry place. Cover it to
protect it from dust if necessary.
7. TROUBLESHOOTING
FAULT
TROUBLESHOOTING
Overheating
Stop the electric scooter until temperature
decreases
Blocked driving wheel
Contact the Cecotec Technical Support Service
It does not turn on
Check the battery is charged
Contact the Cecotec Technical Support Service
ENGLISH
BONGO Z+ ON ROAD
65
BONGO Z+ OFF ROAD
Publicidad
