Rain Bird Modular ESP Guia De Instalación, Programación Y Operación página 58

TROUBLESHOOTING
English
SYMPTOM
Display is partially or
completely blank.
Watering starts when it should
not.
58 Installation, Programming and Operation Guide
POSSIBLE CAUSE
10.The sensor system is preventing irrigation.
11.Start time has not been entered for the program
to which the valve is assigned.
12.Seasonal Adjust for the valve's program is set to
0%.
13.An electrical surge or lightning strike has
damaged the controller's electronics.
14.MANUAL START / ADVANCE key has been
pressed.
15.An unwanted start time may have been entered.
16.The programs may be stacked.
CORRECTION
See correction for Cause #6.
See correction for Cause #2.
See correction for Cause #5.
Push the RESET BUTTON.
If the electrical surge did no permanent damage, the controller will accept
programming commands and function normally. If the controller does not operate
properly, contact Rain Bird Technical Assistance at 800-247-3782.
To cancel a program that has been manually started, set the dial to OFF for three
seconds. Then set the dial back to AUTO.
Turn the dial to SET WATERING START TIMES and check to see if any programs have
an unwanted start time. See page 12 for instructions on setting and eliminating start
times.
Programs will stack behind each other if they are scheduled to start while another
program is running. Make sure Programs A, B, and C are not scheduled to start when
any other program is scheduled.
Rain Bird ESP Modular Controller
®