Franke FHBP 604 4I PW T XS Manual De Instrucciones página 29

Alarm timer function
Service menu/
Manual configuration
Remaining cooking time
You can display the remaining cooking time by touching the hotplate ON/OFF
sensor (A) and then (E+D) or by activating at the same time again and again
(D+E) keys, the time that will be showed is refered to to the zone that displays
the dot blinking.
Shorter residual time will be always shown on timer's display:
▪ In case time is relative to a cooking zone, decimal point will flash at its
display.
▪ In case time is relative to "alarm timer", there is not decimal point flashing.
Switching the timer off
When the preset time expires a beep is heard which you can either turn off by
touching any sensor or leave it to turn off automatically after 2 minutes. When
the programmed time finish also the cooking zone turns off.
Switching the timer of prior expiry of preset time:
• Touch the hotplate ON/OFF sensor (A) to select the desired hotplate.
Decimal dot is on.
• Touch the timer ON/OFF sensors (E+D).
• By touching the sensor »-» (D) set cooking time to »00«. Timer function is
off, but the hotplate continues to operate until you switch it off manually.
Timer can be used as alarm also if it is already employed in timer control of one
of the hotplates. (The hob don't turn off)
Timer setting
With the hob off:
• Touch the hob ON/OFF sensor (C) to activate the cooking hob.
• Touch the timer ON/OFF sensor (E+D) to activate the timer.
• By touching sensors »+« (E) or »-« (D) set the desired time.
Switching the alarm off
When the preset time expires a beep is heard which you can either turn off by
touching any sensor or leave it to turn off automatically after 2 minutes.
If you want to switch the timer off prior expiry of preset time:
With the hob off:
• Touch the hob ON/OFF sensor (C) to activate the cooking hob.
• Touch the timer ON/OFF sensor (E+D).
• By touching the sensor »-« (D) set cooking time to »00«. Alarm function is
off.
Simultaneously touch both »+« and »-« (E+D) sensors and switch the timer
off.
• During the time the alarm is activated, timer can be preset for any hotplate.
Prerequisites for configuration/deleting (configuration)
 All pans must be removed from cooking zones and one suitable for induction
must be available. The size of this pan should be at least 80% of the largest
inductor diameter to be configurated (e.g. inductor Ø200mm→pot size>
Ø160mm)
 It's possible starting configuration/deleting within 2 minutes after connection
to power mains. Touch control and all displays must be turned off.
Getting in configuration/deleting menu'
 Hold the minus key (6) pressed.
 Press all keys of cooking zones' selection anticlockwise, starting off with the
29