first right one (5-4-3-2).
For 4 zones version the sequence is: (5-4-3-2)
For 3 zonesversion the sequence is: (4-4-3-2)
For 2 zones version the sequence is: (4-4-3-3)
Every action is acknowledged by a signal tone:
Only one "beep" → correct selection
#
Double "beep" → wrong selection
#
After the last action all induction displays turn on, where it's displayed:
"-" → it means configured zone
#
"C" → it means NOT configured zone
#
Procedure of deleting configuration
After getting in configuration/deleting menù:
Hold the minus key (6) pressed: "E" is displayed on the displays of all
cooking zones. "E" keeps flashing until all cooking zones will be not
configured.
"C" will be displayed on all displays.
Procedure of configuration
After getting in configuration/deleting menu and completing deleting
configuration:
(During configuration phase all displays of cooking zones display "C")
Cooking zone to be configured can be selected by cooking zone's selection
key.
"C" will start flashing on the corresponding display.
Within 20 seconds a pan must be placed on the corresponding zone in the
way that the cooking zone can detect the correct position.
If within 20 seconds cooking zone detects a pan the simbol "-" will appear
#
(cooking zone is correctly configurated);
If after 20 seconds cooking zone doesn't detect a pan the letter "C" will
#
appear; try again configuration procedure from the first point.
This procedure must be applied to every cooking zone.
Configuration menù stops:
Automatically after the configuration of all cooking zones.
Manually by pressing the key ON/OFF (1), if you want to configure only
certain cooking zones.
If no key is pressed, the menu ends within 2min.
At the end of it it's advisable testing hob to verify that the configuration is
successful.
30