Mechanical Installation; Important Notes - Kollmorgen AKM1 Manual De Instrucciones

Kollmorgen

Mechanical Installation

13
Dimension drawings can be found in chapter "Dimension Drawings" from p.117.
13.1

Important Notes

Only qualified staff with knowledge of mechanical engineering are permitted to assemble
the motor.
— Protect the motor from unacceptable stresses. During transport and handling no
components must be damaged.
— The site must be free of conductive and aggressive material. For V3-mounting (shaft
end upwards), make sure that no liquids can enter the bearings. If an encapsulated
assembly is required, please consult Kollmorgen beforehand.
— Ensure an unhindered ventilation of the motors and observe the permissible ambient
and flange temperatures. For ambient temperatures above 40°C please consult our
applications department beforehand. Ensure that there is adequate heat transfer in
the surroundings and the motor flange, so that the maximum permissible flange tem-
perature of 65°C is not exceeded in S1 operation.
— Motor flange and shaft are especially vulnerable during storage and assembly — so
avoid brute force. It is important to use the locking thread which is provided to
tighten up couplings, gear wheels or pulley wheels and warm up the drive compo-
nents, where possible. Blows or the use of force will lead to damage to the bearings
and the shaft.
— Wherever possible, use only backlash-free, frictionally-locking collets or couplings.
Ensure correct alignment of the couplings. A displacement will cause unacceptable
vibration and the destruction of the bearings and the coupling.
— In all cases, do not create a mechanically constrained motor shaft mounting by using
a rigid coupling with additional external bearings (e.g. in a gearbox).
— Take note of the no. of motor poles and the no. of resolver poles, and ensure that
the correct setting is made in the servo amplifier which is used. An incorrect setting
can lead to the destruction of the motor, especially with small motors.
— Avoid axial loads on the motor shaft, as far as possible. Axial loading significantly
shortens the life of the motor.
— Check the compliance to the permitted radial and axial forces F
When you use a toothed belt drive, the minimal permitted diameter of the pinion
e.g. follows from the equation: d
Servomotors AKM
04/2013
M
³ ´
0
2.
min
F
R
Mechanical Installation
and F .
R A
English - 49