Publicidad
Idiomas disponibles
Idiomas disponibles
3
Part names and functions of the remote
control
■
Before use
When you use the air conditioner for the first time or change the settings, follow the procedures below. From the
next time, just push [
ON/OFF] to start operating according to the settings.
Preparation
Turn on the power breaker
When the power is turned on, " " appears on the remote control display.
* The remote control will not work for about 3 minute after turning on the power. This is not a malfunction.
REQUIREMENT
• Keep the power breaker turned on during use.
• When you resume using the air conditioner after a long period of disuse, turn on the power breaker at least
12 hours before starting operation.
■
Part names and functions
Operating LED
Lights while operating.
1
2
3
Model name label
* The screens shown here are examples. The content that is displayed may differ, depending on the environment
settings being used.
1
[
Menu] button
Shows the "Menu".
2
[
Set/Fix] button
Fixes and applies settings.
Ways to use it are shown on screen.
3
[
Return] button
Deletes selections.
Ways to use it are shown on screen.
15-EN
1140602001_EN FR ES.indb 8
1140602001_EN FR ES.indb 8
For detailed remote control
functions, refer to the Owner's
Manual for the wired remote control.
5
6
Temperature sensor
4
4
[
] and [
] buttons
Changes settings and selects items.
5
[
] and [
] buttons
Selects setting items.
Other ways to use it are shown on screen.
6
[
ON/OFF] button
Starts and stops connected devices.
■
Main screen
This screen is for confirming or changing settings that are used every day, such as temperature, operating mode,
fan speed and wind direction.
You can check the current state according to the setting items on the bottom of the screen.
You can switch the setting items by pushing [
NOTE
• The temperature setting is changed in the main screen.
• Functions and items that cannot be set are not shown, according to the model.
• While changing settings, if you push [
main screen returns.
Switching between the detailed display and simple display (Main screen only)
You can change the main screen to the simple display, depending on the "Display mode" setting. For details on
changing "Display mode", refer to "Display setting" in "Initial setting" in the Installation Manual of wired remote
control.
The detailed display is set as the factory default setting.
Detailed display (Factory default setting)
Simple display
– 8 –
] and [
], and change them by pushing [
] and [
Setting items
•
The currently selected item is highlighted in black.
•
You can switch the items by pushing [
] and [
].
Return] or if there are no button operations for about 60 seconds, the
(*1)
In the simple display, only some icons are shown.
(*1)
*1: "
Preparing to heat"
Displayed when "Heat" operation starts or when
the defrost cycle is operating.
While the icon is displayed, the indoor fan stops or
the "Fan" turns on.
"
Preparing to operate"
This may be displayed on some models.
"
Preparing to operate ventilation"
Displayed while the Heat recovery ventilation unit
is on standby.
While this is being displayed, the Heat recovery
ventilation unit remains stopped.
].
EN
FR
ES
16-EN
4/22/23 4:50 PM
4/22/23 4:50 PM
Publicidad
