Publicidad
Idiomas disponibles
Idiomas disponibles
e. Disconnect the electric cables from the terminal box
(depending on the type of supply, single-phase or three-
phase) (fig. 50).
f. Remove the motor (17).
g. Position the new motor and connect the power cords according
to the wiring diagram.
h. Tighten the cable gland (62) and close the electric box (61)
(fig. 49).
i. Fix the motor (17) to the support (63).
16.
PROBLEMS AND REMEDIES ON THE MACHINE
Problem
The warning light "6" is off.
The mat doesn't get cleaned
17.
DECOMMISSIONING
If the machine remains inactive, is recommended
the service removal or to place a clearly visible
warning note on the machine itself.
The symbol of the crossed-out wheeled bin, present on the
label placed on the appliance, indicates its compliance with the
regulation relating to electrical and electronic equipment waste.
The equipment abandonment in the environment or its abusive
disposal are punishable by the law. We recall that, in view of
the purchase of an equivalent appliance, the manufacturer has
the obligation to freely take-back the product to be disposed of.
The product is not potentially dangerous for human health and
the environment, but if it is abandoned in the environment, it
impacts negatively on the ecosystem.
Disused appliances are mostly made up
of recyclable materials. Please dispose of
them through the authorized operators.
Machine decommissioning must be performed
by authorized and competent personnel, trained
on the correct modes on handling and eventual
dismantling of the machine itself.
Used equipment must be in compliance
with what is required by the regulations and
dispositions in force.
EN - 38
Possible cause
There's no power supply.
---------------------------------------
The general switch (14) is on "0" (OFF).
The bursh is worn.
---------------------------------------
The brush doesn't rotate correctly or rotates too
slowly.
l. Position the pulley (60) on the crankshaft (M) and lock it by
tightening the grub screws (59) (fig. 51).
m. Screw the 4 socket screws (53) without tightening them (fig.
47).
n. Position the belt (58) as described in the paragraph "Belt
replacement" starting from step"g".
Possible solution
Check the power source.
---------------------------------------
Turn on "I" the general switch (14).
Replace the brush.
---------------------------------------
Check the belt status.
---------------------------------------
Check the motor status.
18.
EU DECLARATION OF
CONFORMITY
We hereby declare that the machine described below complies
with the relevant basic safety and health requirements of the EU
Directives, both in its basic design and construction as well as in
the version put into circulation by us. This declaration shall cease
to be valid if the machine is modified without our prior approval.
Product:
AT, AT Fp
AWT, AWT Fp
PT, PT Fp
M 80, M 80 S
M 80 3, M 80 3 S
M 80 Sm
M 80 Sm S
Type: 1.534-xxx
Relevant EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
2014/35/EU
Documentation supervisors:
2022/06/01
Publicidad
