Installation Space; Ambient Working Conditions; Electrical Hook-Up - Corghi EXACT 7000 Manual De Uso

ANIM: "ALL" display of alignment adjustment
help animations on, "FIN" display of non-mov-
ing alignment adjustment help diagrams, "OFF"
alignment adjustment help graphics off.
TRUCK: "ON" truck/trailer program on, "OFF"
program off.
ROMESS: "ON" ROMESS CM-09606 inclinom-
eter automatic connection program on, "OFF"
program off.
ASANTW: "ON" ASA Network program on, "OFF"
program off.
RADAR: "ON" vehicle anti-collision radar calibra-
tion program on, "OFF" program off.
CUSTOM: type of wheel aligner customisation
BD YEAR: year of the latest databank upgrade, if
"DEMO" the aligner card has not been inserted
or is not functioning correctly.

Installation space

WARNING
The installation site must be chosen in compli-
ance with local regulations regarding safety in
the workplace.
The floor must be able to withstand a load
equal to the sum of the weight of the equipment
itself and the maximum payload, bearing in
mind the lift support surface area and anchor
fixtures used.
Place the aligner in the designated work posi-
tion and make sure that the rear panel of the
equipment is at least 10 cm away from the
nearest wall.
IMPORTANT: for correct, safe use of the equip-
ment, users must ensure a lighting level of at
least 300 lux in the place of use.
ATTENTION
Make sure that there are no permanent mag-
nets, electromagnets or large heat sources
close to the equipment (they might damage
the program disk and the Personal Computer
beyond repair).
52

Ambient working conditions

Relative humidity 20% ÷ 80% .
Temperature range 0°C ÷ 40°C.
WARNING
Use of the equipment in a potentially explosive
atmosphere is not permitted.

ELECTRICAL HooK-UP

The manufacturer presets the aligner to operate
with a power supply of 230 VAC. To change this
setting, refer to the "installation" section.
WARNING
Any connections to the workshop electrical
panel are the customer's responsibility, and
must be made by staff qualified in accordance
with the relevant legal requirements.
- The electricity supply must be suitably rated
in relation to:
• the equipment's electrical power absorption,
specified on the equipment's dataplate.
• The distance between the equipment and
the power supply hook-up point, so that
voltage drops under full load do not exceed
4% (10% during start-up) below the rated
voltage specified on the dataplate.
- The user must:
• fit a power plug in compliance with the
current regulations on the power supply
lead;
• connect the equipment to its own electri-
cal connection having a specific automatic
differential circuit-breaker, with sensitivity
30 mA;
• fit protective fuses to protect the power
supply line, rated in accordance with the
instructions provided in the general wiring
diagram in this manual;
• provide the workshop's electrical system
with a protective earth connection circuit
in good working order.
- In order to prevent the equipment being used
by unauthorized personnel, it is advised to
disconnect the power supply plug when the
equipment remains idle (switched off) for long
periods of time.
Operator's Manual EXACT 7000