Ryobi PBC-3046YE Manual De Utilización página 32

GB
F D
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Engine will not start
Lever will not go into the
"COLD START" position
Engine starts but will
not accelerate
Engine does not reach
full speed and emits
excessive smoke
Engine starts, runs,
and accelerates but
will not idle
Blade continues to
rotate at idle speed
E I P NL
TROUBLESHOOTING
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Flooded engine.
4. Starter rope pulls harder now
than when new.
Throttle trigger is depressed.
Carburetor requires adjustment.
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburetor requires adjustment. 3. Turn "H" needle (68) clockwise 1/16 - 1/8 turn
Carburetor requires adjustment.
Carburetor requires adjustment.
S DK N FIN
English
SOLUTION
1. Check spark. Remove spark plug. Reattach the
spark plug cap and lay spark plug on metal cylinder.
Pull the starter rope and watch for spark at spark
plug tip. If there is no spark, repeat test with a new
spark plug.
2. Push primer bulb until bulb is full of fuel. If bulb does
not fill, primary fuel delivery system is blocked.
Contact a servicing dealer. If primer bulb fills, engine
may be flooded (see next item).
3. Remove spark plug, turn trimmer so spark plug hole
is aimed at the ground. Make sure lever is in the
"WARM START" position and pull starter cord 10
to 14 times. This will clear excess fuel from engine.
Clean and reinstall spark plug. With the throttle
trigger fully depressed, pull starter cord three times
with lever at "WARM START" position. If engine
does not start, move choke lever to "COLD START"
and follow normal starting instructions in
"STARTING AND STOPPING" section. If engine
still fails to start, repeat procedure with a new
spark plug.
4. Contact a servicing dealer.
Release throttle trigger. Refer to "Starting and
Stopping" earlier in this manual.
Turn "L" needle (67) counterclockwise 1/16 turn.
If "L" low needle can not be turned counterclockwise,
do not force plastic limiter caps.
Contact a servicing dealer (Fig. 27).
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean air filter. Refer to "Replacing and Cleaning
Air Filter" earlier in this manual.
(Fig.27).
Turn idle speed screw (66) clockwise to increase idle
speed (Fig. 27).
Turn idle speed screw counterclockwise to reduce idle
speed (Fig. 27). If after adjustment, blade continues
to rotate, return to an authorized servicing dealer
for repair.
25
GR H CZ RUS RO PL