Publicidad
Idiomas disponibles
Idiomas disponibles
Filter reassembly:
Insert the active carbon group (F2) on the filter group (F) locking it on the special
g.
tabs (X1) (fig. 36).
Insert the purifying filter (F1) on the first pin on the filter group (X2), pulling it
h.
slightly and locking it on the other two pins present (X3) (fig. 36)
F1
F
Reassemble the filters group (F1-F2) inserting the rear edge inside the grid (fig.
i.
37).
Manually close the air suction grille (3) (fig. 37).
l.
To deactivate the LED A (if on), after cleaning and repositioning the filters, electrically
connect the appliance then press the reset key H briefly using a pointed object.
In this way, the signal relating to the need for filter cleaning is reset.
4.2 - MAINTENANCE
If you plan to idle the unit for a long time, perform the following:
a. Stop the air conditioner and disconnect the power supply.
b. Remove the batteries from the remote control.
EN - 36
F2
F2
X2
X3
F1
X1
36
37
Publicidad
