Publicidad
Idiomas disponibles
Idiomas disponibles
Room temperature probe faulty
Evaporator temperature probe faulty
Evaporator temperature too low
Evaporator temperature too high
Communication error
Evaporating fan motor failure
Water level alarm
1-9: number of flashes (1 flash = 1 second on, 1 second off)
4.3.5 - Anomalies and remedies
Malfunctioning
The unit will not start.
The appliance doesn't
cool/heat sufficiently
anymore.
If the problem has not been solved, please contact the nearest technical
assistance service. Please give detailed information about the malfunction
and on the equipment version.
EN - 40
Cause
Current failure
The unit is disconnected
from the current.
The fuse is interrupted
or the thermal-magnetic
circuit breaker has tripped.
The remote control bat-
teries may be discharged.
The time set with the timer
may not be correct.
Incorrect temperature
setting.
The air filter is dirty.
The doors or windows are
open.
The air inlet or outlet vents
of the indoor or outdoor
units are blocked.
0
1
0
0
2
0
0
3
0
0
4
0
0
5
0
0
8
0
1
1
0
-
0: led off
-
x: indifferent
What must be done?
Wait for the current to be
restored.
Check that the plug is
inserted in the wall socket.
Replace the fuse or restore
the thermal-magnetic cir-
cuit breaker.
Replace the batteries.
Wait or annul the timer
setting.
Set the temperature cor-
rectly. Consul the "Using
the remote control" chapter
for the procedure.
Clean the air filter.
Close the doors or win-
dows.
First, remove the obstruc-
tions and then re-start
the unit.
0
0
0
0
0
0
0
Publicidad
