Publicidad
Idiomas disponibles
Idiomas disponibles
Operation manual - Spider ILD01
conditions.
·
Do not use the mower in limited visibility (dusk,
fog, heavy rain etc.)
·
Do not let the engine run in enclosed spaces.
The exhaust gases contain CO, they damage
health and can ultimately cause death.
·
The engine should only be started and operating
in open spaces. If the engine is started and
operated in enclosed spaces, the exhaust gases
must be conducted away by the means of
prolonging the exhaust pipe outside the enclosed
space. Proper ventilation and fresh air supply
must be secured in order to prevent the
accumulation of CO.
·
Before storing the machine in a closed space, let
the engine and the hydraulic drive of the machine
cool properly.
·
Regularly remove all combustible objects (dry
grass, leaves...) from the areas around the
exhaust pipe, engine, and battery.
·
Always control the machine from a working
station, which gives you a perfect view of the
whole working area and of the machine.
·
While working, change your working position to
have a perfect view of the mower at all times.
·
When operating the mower on slopes never enter
the space directly below the mower.
·
The working position should be far enough
(maximum 50 meters) to prevent the operator
from getting hit by objects that may be
accidentally thrown by the mower.
·
Do not operate the mower if you cannot see it
(behind terrain obstacles, corners of buildings,
hidden in grass etc.)
Safety Decals
·
Before starting the mower, check the state of the
safety labels. If any labels are damaged or
missing, contact your dealer and replace such
labels on the machine. Get thoroughly
acquainted with these labels. The placement of
the labels on the machine is obligatory.
·
Do not remove or damage any of the safety
labels.
·
Do not remove any covers or safety elements.
They are for your protection.
·
Do not use the machine if any of the protecting
devices or covers are damaged or missing.
·
Keep the machine and its accessories clean and
in a good technical condition at all times.
·
It is strictly prohibited to make any changes or
modifications to the machine that were not
previously approved by the manufacturer. Any
modification to the machine may lead to a
hazardous situation or injury. If these instructions
are not followed, the manufacturer does not bear
any liability for the machine and the terms of
warranty may be invalidated..
·
The machine must always be equipped with all
covers and protective elements.
10 / 54
rev. 07-01-01-2010
Publicidad
