Publicidad
Idiomas disponibles
Idiomas disponibles
Operation manual - Spider ILD01
11.8 DRIVE V-BELTS
Check the wear and tension of the V-belts and the
tensioning devices.
a)
Hydraulic pump drive
Located under the cutter deck inside cover A.
The V-belt is tensioned automatically by a spring
and a tension
pulley.
b)
Travel wheels drive
The V-belt is tensioned by a tension pulley B.
11.9
GEOMETRY ADJUSTMENT
If you do not possess necessary equipment and
skills, have this work performed by an authorized
service/dealer.
- Lift the mower (wheels above ground) and
position the wheels into a straight
- Release the steering chain taper lock (figure
91).
- Place a straight lath to the wheel portal on the
left side and to the tyre disc on the right side
and adjust the wheels so that they are parallel
(figure 92, figure
93).
- Tighten at least 1 screw of the taper lock
(whichever is accessible). Do not turn the
wheels unless you have tightened at least one
screw - this would distort the
- After tightening one screw you can turn the
wheels.
- Tighter the second
- Check the geometry with a
- Step-by-step turn wheels and tighten both
screws of the taper locks of all wheels until
they are completely tightened (cca 23
direction.
geometry!
screw.
lath.
Nm).
39 / 54
A
Picture 91.
Picture
92.
93.
Picture
rev. 07-01-01-2010
Publicidad
