Descargar Imprimir esta página

Textron Ransomes Spider I Manual De Seguridad, Funcionamiento Y Mantenimiento página 30

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation manual - Spider ILD01
10.2. STARTING THE ENGINE OF THE MOWER WITH THE HETRONIC REMOTE
CONTROL
Check the gasoline in the fuel tank, refuel
with unleaded gasoline BA95 if
necessary.
Check the position of the blade drive lever
switch (5) on the remote radio controller.
The controller must be in the OFF
position.
Check the forward/reverse control joystick
(7 on the remote radio controller and
leave it the neutral position.
Switch ON the remote radio controller
power switch (9) by turning clockwise.
The controller will beep after a few
seconds and lamp 10 will illuminate.
Unless switch 5 is in the OFF position,
button 9 in the ON position and the
EMERGENCY STOP button in the
raised position, the machine will not
start.
Ensure the EMERGENCY STOP button
on the remote radio control is in the raised
position.
Set the engine choke control to the
position for cold start - the lever is pulled
up (only for the first start or if the engine is
cold). See the engine user's manual.
Use the key to unlock and pull up the
EMERGENCY STOP button on the
mower.
Wait till LED number 2 on the mower
starts to shine (about 10 seconds).
Press the horn button on the remote radio
controller – the mower ignition engages.
Press the START button (4) on the
remote radio controller.
The engine is "running", release the
START button on the remote radio
controller. While the engine is working do
not use the START button again.
Let the mower idle for about 2 – 3 minutes
without engaging the mowing device and,
while the engine is warming up, push
back the choke control (in the case of a
cold start).
For 5 seconds after the engine has
started all motion functions of the mower
are blocked – they can be unblocked by
pressing the horn button 11.
NOTICE:
Do not stand right next to the mower while
starting it
30 / 54
rev. 07-01-01-2010

Publicidad

loading

Este manual también es adecuado para:

Ild01w