Publicidad
Idiomas disponibles
Idiomas disponibles
Operation manual - Spider ILD01
AMPV
NOTICE: if indicator lamp number 4 is illuminated or either of the indicator lamps 1, 2, 3 is dimmed, the mower
cannot be started.
Remedy:
•
Indicator lamp number 1 is dimmed – try to turn the key in the ignition again.
•
Indicator lamp number 2 is dimmed – try restoring the signal between the mower and the RC by
switching the RC off and on again and by checking the aerial on the mower.
•
Indicator lamp number 3 is dimmed - move the forward/reverse joystick and set neutral position of the
hydraulic gear.
•
Indicator lamp number 5 is illuminated – set the mowing mechanism clutch engagement /
disengagement controller to the OFF position.
AW 733
After the power supply is turned on, indicator lamp 1 will be illuminated. The following actions take place:
•
Initialisation of the processor, check of radio connection and check the communication with the
hydraulic pump servo-motor. If the hydraulic pump servo-motor is in the neutral position, indicator
lamp 3 will illuminate.
•
After the radio controller is turned on and communication is established between the machine and
remote controller, indicator lamp 2 will illuminate.
•
If the blade magnetic clutch is engaged, it is not possible to start the engine and the horn will sound. It
will require the blade to be turned off on the radio control unit.
•
If the mower battery has insufficient charge the horn will sound.
•
When the engine is running the batteries are constantly checked, if the battery is exhausted or drops
below 11.7 volts the horn will be sounded repeatedly.
AW 891
After the power supply is turned on, indicator lamp 1 will be illuminated. It will flash for seven seconds, during
this period the following actions take place:
•
Initialisation of the processor, check of radio connection and check the communication with the
hydraulic pump servo-motor. If the checks are successful lamp 1 will illuminate. If a malfunction is
detected lamp 1 will flash.
•
When there is communication between the machine and the radio control unit, lamp 2 flashes. If there
is a break in communication lamp 2 dims and lamp 1 flashes.
•
After the processor is initialised lamp 3 illuminates and a battery voltage is checked. If the battery has
insufficient charge, lamp 3 flashes.
•
When the engine is running the batteries are constantly checked, if the battery is exhausted or drops
below 12 volts, lamp 3 flashes.
•
While the blade is engaged, lamp 4 is illuminated. The mower cannot be started when this lamp is
illuminated.
NBB
After the power supply is turned on, indicator lamp 1 will be illuminated. It will flash for seven seconds, during
this period the following actions take place:
•
Initialisation of the processor, check of radio connection and check the communication with the
hydraulic pump servo-motor. If the checks are successful lamp 1 will illuminate. If a malfunction is
detected lamp 1 will flash.
•
When there is communication between the machine and the radio control unit, lamp 2 flashes. If there
is a break in communication lamp 2 dims.
•
Lamp 3 is illuminated when the drive servomotor is in a neutral position.
•
Lamp 4 is illuminated while the blade is engaged. The mower cannot be started while this lamp is
illuminated.
22 / 54
rev. 07-01-01-2010
Publicidad
