Publicidad
Idiomas disponibles
Idiomas disponibles
Operation manual - Spider ILD01
DRIVE
The maintenance of the hydraulic drive requires
properly trained service personnel.
Regular maintenance should address the torque
of hydraulic connections and bolts, replacement
of pressure hoses and oil refilling.
The maintenance of the hydraulic
parts must be carried out in a very
clean working area. Any contamination
brought into the hydraulic circuit may cause
damage. If replacing any part, remove all
contamination by rinsing it with cleaning fluid.
The hydraulic drive must never work
without or with an insufficient amount
of oil, not even for a short time
11.7 ADJUSTMENT OF THE NEUTRAL POSTION OF THE HYDRAULIC DRIVE
This adjustment should only be performed by an authorised service/dealer.
11.6 CHECKING AND REFILLING OIL
Check the oil level in the hydraulic oil tank daily.
Measure the oil level with the dipstick in the cap of
the tank. The oil level must be between the limit
marks. If you are working in extreme conditions,
the level of oil (at ambient temperature) must
reach the upper limit mark on the dipstick.
When checking the oil, the engine must be off and
the oil cold.
If you are checking warm or hot oil,
the level of oil may be higher (and
reach above the limit mark) due to
the oil volume expansion.
Do not overfill the hydraulic
38 / 54
tank!!!
rev. 07-01-01-2010
Publicidad
