Publicidad
Idiomas disponibles
Idiomas disponibles
Operation manual - Spider ILD01
Instructions for turning on and off the hydrostatic winch
Rotate the machine so that the winch
is facing up the hill toward the
expected anchoring point.
On the control panel on the machine
turn on the hydrostatic winch by the
ON-OFF switch.
Turn on the blades
Place the mower at the bottom of the
slope
Loosen the winch rope by pushing the
drive joystick slightly backward.
Turn the wheels so that they are
orientated across the slope (along the
slope contours)
By pushing the driving joystick
slightly backward the rope will begin
to unwind. Fasten the rope properly
to the anchoring point.
Leave the anchoring position of the
mower by pushing the driving joystick
forward and by driving up the slope.
Turn the wheels across the slope,
perpendicular to the anchoring point
Untie the rope from the anchoring
point. Wind the rope back onto the
winch drum by pushing the drive
joystick slightly forward.
Turn off the blades
Increase the engine RPM to maximum
Method of cutting up and down a
slope: driving up the slope – push the
joystick forward, driving down the
slope – push the joystick backward
Turn off the blades
On the control panel on the machine
turn off the hydrostatic winch by the
ON-OFF switch.
17 / 54
Reduce the engine RPM to minimum
(idling speed)
Tighten the winch rope by pushing
the driving joystick slightly in the
forward direction.
Method of cutting across the slope:
Drive according to the picture. The
joystick should always be pushed in
the forward direction..
Reduce the engine RPM to minimum
(idling speed)
Check the overall condition of the
winch. The rope and the snap hook
must not be damaged.
rev. 07-01-01-2010
Publicidad
