Publicidad
Idiomas disponibles
Idiomas disponibles
Operation manual - Spider ILD01
10.5 ENGAGING THE MOVING BLADES
The mowing blades can only be engaged when the
engine is running.
Set the maximum mowing height with switch (6).
Move the switch (5) of the blade-drive clutch to the
ON position on the remote radio controller (NBB RC:
firts increase engine speed by regulator 14) – the
mowing device engages after four seconds.
Set the working position of the blade by the mowing
height switch (6) on the remote radio controller-
hetronic rc, (7)-NBB - rc
Do not engage the mowing blades in tall
grass, damage to the clutch may result. If
you wish to mow tall grass, move the mower
to a place without tall grass and then turn
the blades on. When engaging the blades stand in a safe
distance from the mower. Do not engage the blades if
there are people near the mower. The rotating blades may
throw objects.
10.6 DISENGAGING THE BLADES
Move switch (5) blade drive to the OFF position –
the mowing device disengages (NBB: press button
13 to disengage the
blade).
to mow anymore, set the maximum height with
switch (6) on the remote radio controller
(7)-NBB rc.
10.7 HEIGHT OF CUT ADJUSTMENT
The machine has a variable mowing height. The
mowing height can be from 60 to 110 mm as a
standard.
The mowing height can be adjusted by switch (6) on
the remote radio controller Hetronic rc, (7)-NBB rc.
Follow the marks on the body of the mower.
If the grass growth is high or wet, select a higher
mowing
position.
The lowest position is used when mowing well-
maintained and even
areas.
when mowing unknown areas for the
first time, we recommend to mow with
blades in a higher position and - after
finishing mowing - to re-examine the
area for undesirable objects. The next
cut should
only be done after the grass cuttings have died.
Set the height of cut approximately, mow a few meters
of the area and check that the height of the cut grass
meets you expectations.
The height of cut on a slope may
significantly vary from that on a level
surface.
If you are not planning
–Hetronic rc,
32 / 54
8
11
12
4
7
Switch (6)-Hetronic, (7)-NBB has 3
positions:
minimum limit position and the third
intermediate position, which preserves
the current height set-up.
Cleaning the mowing mechanism
After each use the mowing mechanism must be
carefully cleaned, especially the inner walls of the
mowing deck. The cleaning should be carried out
with a scraper. The mower must not be washed by
power washer or other high-pressure devices.
When cleaning, secure the machine against
moving.
Raise the mowing mechanism to the transporting
position. When cleaning, also check the blades.
Proper maintenance and treatment of the mowing
mechanism increases the quality of work and
durability of your machine.
After cleaning and drying, especially if the mower
will not be used for a longer time, treat all
scratched parts with preservative coating.
If you are lifting the mower during cleaning, make
sure that you secure it against movement and fall.
Remove the spar plug terminal and press the
EMERGENCY STOP button on the mower.
14
2
9
3
1
13
6
5
The
maximum
and
rev. 07-01-01-2010
Publicidad
