Cleaning; Recalibration - WIKA GDI-100-D Manual De Instrucciones

8. Maintenance, cleaning and recalibration
8.3

Cleaning

CAUTION!
Physical injuries and damage to property and the environment
Improper cleaning may lead to physical injuries and damage to property and
the environment. Residual media at the dismounted instrument can result in a
risk to persons, the environment and equipment.
▶
Use the requisite protective equipment.
▶
Carry out the cleaning process as described below.
1. Prior to cleaning, isolate the instrument properly from the pressure source and switch
it off.
2. Use the requisite protective equipment.
3. Clean the instrument with a moist cloth. Electrical connections must not come into
contact with moisture!
CAUTION!
Damage to property
Improper cleaning may lead to damage to the instrument!
▶
Do not use any aggressive cleaning agents.
▶
Do not use any hard or pointed objects for cleaning.
▶
Do not use solvents or abrasives for cleaning.
4. Wash or clean the dismounted instrument, in order to protect persons and the
environment from exposure to residual media.
8.4

Recalibration

We recommend that the instrument is regularly recalibrated by the manufacturer, with
time intervals of approx. 12 months. The basic settings will be corrected if necessary.
The calibration label is attached at the side of GDI-100-D. For instruments with protective
rubber cap, the calibration label is located beneath the protection cap.
Fig. 2 - GDI-100-D with protective rubber cap
WIKA operating instructions, model GDI-100-D
Fig. 3 - GDI-100-D without protective rubber cap
EN
35