Descargar Imprimir esta página

Toro 76605 Manual Del Operador página 38

Cortacésped giro cero de asiento de 152 cm (60')
Ocultar thumbs Ver también para 76605:

Publicidad

Idiomas disponibles

Idiomas disponibles

Hauling the Machine (continued)
Loading the Machine
Loading a machine onto a trailer or truck increases the possibility of tip-over and
could cause serious injury or death.
• Use extreme caution when operating a machine on a ramp.
• Back the machine up the ramp and drive it forward down the ramp.
• Avoid sudden acceleration or deceleration while driving the machine on a ramp as
this could cause a loss of control or a tip-over situation.
1. If using a trailer, connect it to the towing vehicle and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Lower the ramp, ensuring that the angle between the ramp and the ground does not
exceed 15 degrees.
Operation: After Operation
G027996s
WARNING
Page 4–19
Full-width ramp(s) in stowed
position
Side view of full-width ramp in
loading position
Not greater than 15 degrees
Ramp is at least 4 times as long as
the height of the trailer or truck bed to
the ground
H = height of the trailer or truck bed
to the ground
Trailer
3465-582 A

Publicidad

loading