Publicidad
Idiomas disponibles
Idiomas disponibles
Leveling the Mower Deck (continued)
3. Position 1 blade front-to-rear.
4. Measure at locations
surface to the cutting edge of the blade tips
The front blade tip should be 1.6 to 7.9 mm (1/
16 to 5/16 inch) lower than the rear blade tip. If
the measurement is not correct, adjust the
front-to-rear level.
Leveling the Mower Deck
1. Set the anti-scalp rollers to the top holes or remove them completely for this procedure.
2. Set the height-of-cut lever to the 76 mm (3 inch) position.
3. Place 2 blocks
6.6 cm (2-5/8 inches), under each side of the
front edge of the deck.
Do not place the blocks under the anti-scalp roller brackets.
4. Place 2 blocks
the rear edge of the deck.
3465-582A
and
from a level
, each having a thickness of
IMPORTANT
, each having a thickness of 7.3 cm (2-7/8 inches), under each side of
Page 5–28
.
G414700
G453680
Maintenance: Mower-Deck Maintenance
Publicidad
