Toro 76605 Manual Del Operador página 48

Engine-Oil Service (continued)
3. Slowly add the specified oil into the filler tube to bring the oil level to the Full mark.
Servicing the Spark Plug
Ensure that the air gap between the center and side electrodes is correct before installing
the spark plug. Use a spark plug wrench for removing and installing the spark plug and a
gapping tool or feeler gauge to check and adjust the air gap. Install a new spark plug if
necessary.
Type: NGK® BPR4ES
Air gap: 0.76 mm (0.03 inch)
Removing the Spark Plug
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Clean the area around the base of the plug to keep dirt and debris out of the engine.
4. Remove the spark plug.
Maintenance: Engine Maintenance
G398545s
G235264s
position.
ARK
Page 5–9 3465-582 A