Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the Mower Belt (continued)
6. Using a spring-removal too (Toro Part No. 92-5771), remove the idler spring from the
deck hook to remove tension on the idler pulley.
The spring is under tension when installed and can cause personal injury.
Be careful when removing the belt.
7. Roll the belt off the pulleys.
8. Route the new belt around the engine pulley and mower pulleys.
9. Use the spring-removal tool to install the idler spring over the deck hook and place
tension on the idler pulley and the mower belt.
10. Position the wire form against the idler arm as shown and tighten the nut.
3465-582A
G453683
WARNING
G453682
Page 5–22
Deck pulley
Mower belt
Engine pulley
Idler pulley
Spring
Spring-removal tool
Maintenance: Belt Maintenance
Publicidad
