Publicidad
Idiomas disponibles
Idiomas disponibles
Blade Service (continued)
4. Rotate the same blade 180 degrees so that the opposite blade edge is now in the same
position.
5. Measure from the tip of the blade to the level surface.
6. If the difference between A and B is greater than 3 mm (1/8 inch), replace the blade.
Note:
the blade spindle could be bent. Contact an Authorized Service Dealer for service.
7. Repeat this procedure each blade.
Maintenance: Mower-Deck Maintenance
G451422
G451423
G451422
If you replace the blade and the difference continues to exceed 3 mm (1/8 inch),
Page 5–25
Blade (in position for measuring)
Level surface
Measured distance between blade
and the surface (A)
Blade edge previous measured
Opposite blade edge
Blade (in position for measuring)
Level surface
Measured distance between blade
and the surface (B)
3465-582 A
Publicidad
