Publicidad
Idiomas disponibles
Idiomas disponibles
Insert push handles at least in the frame tube. Secure them at the desired height by turning the
locking lever clockwise. Adjust both handles to the same height.
The push handles must be adjusted parallel to the direction of movement!
Maximum permissible angle between the longitudinal center line of the handle and the direction of
movement is 0°.
If braking is poor or too hard, the brake can be adjusted either at the brake housing above or using the adjusting screw on the
Bowden cable below to achieve the desired braking effect.
The brake is correctly adjusted when the brake levers as well as the brake wires are free of play and the wheels can be rotated
without grinding noises when the brake is released.
USE OF BRAKE HANDLES :
To brake when walking with the rollator, pull both break handles upwards with your hands. Always brake slowly while applying
equal pressure with both hands.
To apply the brakes/park the rollator, press both break handles downwards until they audibly click into place! To release the brake,
pull both brake handles upwards once again until they are released (brake handles are in the middle position). The braking effect
can be impaired by wear and tear on the tires. For this reason, regularly check the braking effect.
DMI-F-10_Annexe 2_Notice.10
Mai 2023
The position of the adjustment knob itself can be adjusted by simultaneously pulling and
rotating it. To change the height setting of the push handles, rotate the adjustment knob
counterclockwise in order to release the fixation. Then lock the handle at the desired height, as
described above.
BRAKE ADJUSTMENT :
Page 9 sur 16
Publicidad
