Anleitung HT 1600-1801-F
Pistol safety lock
Always actuate the safety lock (S) on the pistol whe-
never the machine is not being used. This will pre-
vent the machine starting up accidentally.
Starting up and notes on operation
1. Plug the unit into the mains (see the sections
„Safety regulations" and „Electrical connection").
2. Open the water tap (see the sections „Steps
before putting the unit into operation" and „Water
connection").
3. Bleed the system of air by pulling the pistol
trigger.
09.11.2001 7:51 Uhr
4. Switch on the cleaner with the pistol open (move
To purge any particles which may have accumulated
inside the cleaner system, we recommend spraying
for 1-20 seconds with the spray pistol only. Such par-
ticles could block the high-pressure nozzle and jeo-
pardize its proper operation.
Never clean the high-pressure nozzle with sharp
metallic objects. Use only blasts of compressed air.
Spraying with cleaning agents
Remove the front section of the lance and fit the
foam-spray attachment in its place. Then fill the
container with a suitable cleaning agent and screw it
into the nozzle holder. When you pull the pistol
trigger, the cleaning agent is drawn automatically
from the container and sprayed with the water.
If the cleaning agent is not longer needed, you must
remove the attachment and refit the normal lance
section.
Instructions for the proper use of cleaning
agents
It is not advisable to use intensively foaming or acidic
cleaning agents. Use only standard brand-name
products.
Seite 15
the power switch on the cleaner to position 1).
Make up cleaning agents in their correct ratio of
concentration (follow the manufacturer´s
instructions).
Distribute the cleaning solution evenly over the
surface to be cleaned with the high-pressure
cleaner and allow the solution a few minutes to
work (be careful when working on hot surfaces,
e.g. engines or objects exposed to bright
sunshine).
Finally, rinse down the treated surface uniformly
with water from the high-pressure cleaner.
GB
15