EINHELL HT 1600-F Instrucciones De Servicio página 16

Anleitung HT 1600-1801-F
GB
Important:
For safety reasons, always switch off the motor
before changing the nozzle!
Changing over from round-jet to fan spraying
You can spray with either a round jet or fan jet as
required.
To adjust, simply turn the nozzle head to the right (1)
for a round jet or to the left (2) for a fan jet (see
picture).
Shutting down
Important!
Whenever you stop working and switch off the pump,
always depressurize the system by opening the
pistol.
Switch off the unit Close the water tap
16
09.11.2001 7:52 Uhr
Shutting down for longer periods
If you do not intend to use the high-pressure cleaner
for a longer period of time, we recommend rinsing
the system thoroughly with an ample amount of
water. Use clean water without cleaning agents.
Antifreeze precautions
When the unit is stored away, it must be protected
from freezing up.
If you have to use a storage room that is very cold or
exposed to frost, it is advisable to fill the unit first with
an antifreeze agent. The unit can draw in the anti-
freeze most easily if the container is held at a higher
level.
Monitoring and maintenance
Important!
Before beginning repair or maintenance work,
always remove the plug from the mains socket.
Repairing the cleaner while it is still connected to
the mains current supply is extremely dangerous
and can be fatal!
The machine requires no maintenance. It is delivered
with enough oil for it to be used for around 300
hours. You must then arrange for a service workshop
to change the oil.
Water supply
If the water supply line is excessively dirty, install a
filter in the water inlet.
Hoses
The high-pressure cleaner is equipped at the factory
with hoses designed for its operating pressures. If
these hoses need replacement, only ever use the
manufacturer´s original hoses or types of identical
quality bearing the necessary markings.
Important!
Pull the plug out of the
Never draw solvents such as paint thinners,
socket
gasoline, oil, etc. or unfiltered water into the
cleaner. The seals in the system are not solvent-
proof. Solvent mist is highly flammable, explosi-
ve and poisonous!
Seite 16