EINHELL HT 1600-F Instrucciones De Servicio página 17

Anleitung HT 1600-1801-F
Checking the water intake filter
Check the intake filter at set intervals in order to
avoid clogging. Failure to do so may jeopardize the
proper operation of the pump (see the figure).
Decalcifying
You must decalcify the high-pressure cleaner at
regular intervals. Just how frequently this is
necessary will depend on the hardness of the water
in your area.
Pour the decalcifier into a container with a capacity
of at least 30 litres and mix with water in a ratio of 1
litre of decalcifier to 15 litres of water.
09.11.2001 7:52 Uhr
Inlet
Filter
Seite 17
Use the high-pressure cleaner with a hose to draw
up the mixture. Submerge the pistol immediately in
the container to create a closed-circuit and allow the
decalcifying solution to circulate for at least 10 minu-
tes (leave the unit switched on).
You will find it easier to start up the circulation if you
place the container above the pump.
Important!
Decalcifier is caustic! Observe the manufactu-
rer´s safety precautions printed on the
packaging!
Fitting the wheels and stand
You can make your high-pressure cleaner mobile by
fitting the supplied wheels and stand. The wheels are
simply inserted in the prepared holes on the sides
and the stand is plugged in place on the bottom of
the housing (see drawing).
Insert the steering handle in the guide slot on the
housing. The handle latches home in bottom and top
position. To release the catch, press in the two lugs.
You can then move the handle in or out as required.
GB
17